EK1100 - New (S1), See Description

BECKHOFF EK1100 | EtherCAT Coupler

The EK1100 coupler connects EtherCAT with the EtherCAT Terminals (ELxxxx). One station consists of an EK1100 coupler, any number of EtherCAT Terminals and a bus end terminal. The coupler converts the passing telegrams from Ethernet 100BASE-TX to E-bus signal representation.

The coupler is connected to the network via the upper Ethernet interface. The lower RJ45 socket may be used to connect further EtherCAT devices in the same strand. In the EtherCAT network, the EK1100 coupler can be installed anywhere in the Ethernet signal transfer section (100BASE-TX) – except directly at the switch. The couplers EK9000 and EK1000 are suitable for installation at the switch.

S1 - Our S1 designated products are new parts, never used, in original manufacturer packaging and may be an older date code, firmware, series or style. When purchasing S1 products, please verify series and firmware if applicable. All units will have been tested when required and consequently may not carry the original factory seal.